With the spring tension of the hammer J spring and the hammer spring legs against the pins, the surface tension of the pins against the FCG prats themselves is greater than the receiver hole tensions, and the pins will spin.
Now regarding the Tm's, pulling the FCG is not advised by the common shooter/solder, but you have to remember that one of the specification for the ammo to be used is that the primers are to be staked in to the cases to prevent them from being lost/blown into the receiver cavity/action. Translating this to civilian ammo and shooters, it is not uncommon to have a blown primer every blue moon that makes it way under the trigger and disables the rifle. Since the standard FCG with standard pins can be disassembled with nothing more than a bullet tip and stick if needed, the slight wear to the receiver caused by the pins rotating outweighs a tool needing to be used pull the FCG (read if you do have the allen wrench when it does happen). Also, since USGI receivers are still in service after hundred of thousands of rounds using/with the standard pins rotating, worrying about pin wear on a properly lubed/maintained rifle is way over the top.
Now since KNS pins have been bought up, you really need to keep in mind that nature of the beast.
Te real rifle that benefits from the KNS pins is the 9mm (blow back type units). On these units, the hammer tension against the non-ramped bolt (carrier since it’s all one part) is part of the equation of the mass that holds the bolt forward against the barrel during the blow back action of the system. Do to this non ramped edge to smooth out the hammers transition movement, the 9mm unit hammers can do a number of the hammer pin, and even oblong the receiver hole in a very short time.
The pins themselves on the KNS unit are not stronger than standard FCG pins, but if the hammer pin does snap, it is at least retained in a semi normal position and the rifle will continue to the rifle. Also, since the two pins are linked together, these helps to reduce the obliging of the receiver’s hammer pinholes since the pressure of the hammer to the pin is transferred to both pins.
The draw back to the KNS pin system, even in the blow back units, is that there will be more wear from the FCG to the pin it’s self since the pins do not rotate with the FCG. And as stated above, if the FCG needs to be pulled (such as a blow primer, or mantiance), a allen wrench is needed to pull the pins.
If you feel that the increase longevity of the 223/5.56 Nato lower receiver to be passed on to future generations (read being able to take the lower past the 300,000 round mark), out weights the need to ready available pull the FCG (pins) without special tools, then by all means, buy the KNS set for the rifle.