Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
User Panel

Page AR-15 » Troubleshooting
AR Sponsor: bravocompany
Posted: 6/21/2003 4:31:10 PM EDT
The rear take-down push-pin on my PWA Commando lower is stuck shut.  It will push out a few millimeters, but then stops dead.  Is there anything I can do short of disassembling the telestock?

Also, how do you inspect the push-pins to ensure that the detente holes aren't too deep?

Thanks!

Andy
FT Bragg, NC
Link Posted: 6/21/2003 5:48:23 PM EDT
[#1]
Remove the butt stock assy. and the rear pushpin detent and spring will fall out.Tap pushpin out and clean pinhole/pushpin  of corrosion.Re-install test for function.
Link Posted: 6/22/2003 4:09:21 AM EDT
[#2]
If you've tried lubing the heck out of it and cussing then you probably need to take the stock off.  The pointy end of your detent pin may have snapped off.  Good luck.
Page AR-15 » Troubleshooting
AR Sponsor: bravocompany
Close Join Our Mail List to Stay Up To Date! Win a FREE Membership!

Sign up for the ARFCOM weekly newsletter and be entered to win a free ARFCOM membership. One new winner* is announced every week!

You will receive an email every Friday morning featuring the latest chatter from the hottest topics, breaking news surrounding legislation, as well as exclusive deals only available to ARFCOM email subscribers.


By signing up you agree to our User Agreement. *Must have a registered ARFCOM account to win.
Top Top