Hi,
About a year ago, I found an 80% ar receiver on e-bay.
I e-mailed the seller. He said he wire EDM's the mag well. I remember his add said he now engraved "fire" and "safe" onto the receiver.
I am now ready to start my ar project (promised the wife I would finish the new workshop before I started using it) but I can't find his e-mail anywhere.
Does anyone have any idea who this might have been?
Second thought...
I want to start with a forging (should be much stronger than a casting). I was worried about a broach cut mag well not being as accurate as a wire EDM cut unit.
Am I being too fussy? I want to make an accurate target rifle. I've read all the articles and books on making an ar accurate. Most books just say "use a quality receiver". Use of ovesized pins with anti-walk clips, custom fitting (minimum side clearance) of the trigger into the receiver and use of an accu-wed seem be all they metion on the reciever?
Any thoughts???
Thanks ..... Mike