hey, i was hoping you guys could help me.
im going to make this hopefully as clear as possible.
how does burris measure its scope rings? is it from the bottom of the scope to the VERY bottom of the mount....
or is it from the bottom of the scope to where the scope ring comes into contact with the top of the picatinny rail.
so if i were to order a 1" high burris xtr ring, and mounting it all up on my rifle would it measure 1" from the bottom of the scope to the top of the rail, or from the bottom of hte scope to the very bottom of the scope mount?
hopefully this is clear enough. i picked up some other scope rings in high(which should be 3/4") and they seem to be measured funny so they are to small.
so im trying to figure out if i need high(3/4"), or x-high(1") xtr rings. my scope has a 42mm objective...