OK I'm looking at either the Dillon XL 650 or the Super 1050, how do these work for loading mass quantity for shooting up as well as precision rounds for all out accuracy?  Should I be looking at different manufactures? Thanks

Quoted: OK I'm looking at either the Dillon XL 650 or the Super 1050, how do these work for loading mass quantity for shooting up as well as precision rounds for all out accuracy?  Should I be looking at different manufactures? Thanks

650 will work fine, the 1050 is overkill, speeds not that much faster than a 650, in fact a 550 will do you  proud too.

I use a Rockchucker to single stage size all my .223 brass then tumble the lube off, that leaves me with a sized clean case which I can decrimp the primer pockets or trim them if need be, then I knock them off with the 550B

Of course you can use the 650/1050 to just size first, decrimp/trim, then finish them off on the same presss

Come on over the the Reloading board in the General section.