Hope this is in the right place--so here is how it goes. Picked up a new 6920 last weekend and got around to trying it out today. Setup is as follows: Larue LT104 mount with a Leupold VX-R 4-12x40 and the factory colt A2 front sight/Magpul flip-up rear irons. I get set up at 50 yards and the thing won't hit paper with the scope. Tried the old school peer through the bore and align reticle, and get nowhere close. After fiddling around wasting about 10 rounds down the pipe, I tried the center area between the two targets I had setup and discovered it appears to be shooting left about 12-14" and 4" high. Obviously the scope doesn't have that much adjustment. For shiz and giggles, I tried the irons and got the same result. Can one assume the barrel is bent/pointed about a mile to the left? The next question is: has anyone dealt with their warranty dept? I'm hoping I can get away with only sending the upper if I have to. Thoughts/advice/comments appreciated.