Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 9/13/2010 9:51:32 AM EDT
I need to get my lower shipped out to be engraved and they want the stock and buffer tube removed before I do so. I was just wondering if anyone would be willing to let me borrow their wrench or let me just stop by with the lower and use theirs real quick, Im gonna order one but don't want to wait another week before shipping my lower out.

Thanks so much for the help
Link Posted: 9/13/2010 1:51:34 PM EDT
Sent you an IM give me a ring if you still need to use the wrench.

Bryan
Link Posted: 9/13/2010 2:32:01 PM EDT
IM sent in case a wrench is still needed.
Link Posted: 9/13/2010 7:14:01 PM EDT
Borrowed a wrench from Testify4 so thanks guys

Now if i could just get this damn thing off....
Link Posted: 9/13/2010 9:35:34 PM EDT
Originally Posted By tx1021:
Borrowed a wrench from Testify4 so thanks guys

Now if i could just get this damn thing off....


is it staked? If so, you might have to get the dremel out. If it's not staked, it's probably loctite. You will need to heat it up with a handheld torch for a bit to loosen the loctite up and then it should spin off.

Link Posted: 9/13/2010 10:26:20 PM EDT
It isn't staked. I might take a torch to it but I'm really paranoid about messing the receiver up so i dont know...
Link Posted: 9/14/2010 6:48:14 AM EDT
[Last Edit: 9/14/2010 6:49:23 AM EDT by micah360]
you wont mess the receiver up. Just use a little propane torch and heat the nut up a bit.

and a receiver vice block helps a lot too.
Top Top