Have for sale one Tactical Custom Bolt Action Rifle in .300 Remington Ultra Mag. This was a total custom built rifle from the ground up, has never been fired except by the gunsmith two rounds exactly to test crown. Complete with rings, base, scope, rifle, everything. 1/4-1/2MOA fully blue printed rifle. Parts alone are worth $1500 not including total build fees from a true professional.
Rifle caliber for .300 Ultra Mag was picked for several reasons; pushes about 10% greater than .300WM, but has energy nearly 20% greater. UM uses non-belted casings, full chamber fit, unlike WM belted. Easy to re-load using easy to find .30 cal bullets, gives equal accuracy between once fired brass or store bought ammunition. Pushes muzzle velocity from 3400FPS to 3650FPS. Drops less than 24" at 500 meters using 150gr bullets but you can push up to 220 grains for hunting. Rifle is the ultimate combination for field portability (11.3 lbs complete), easy to reload and easy to find ammo. Fastest flattest shooting .30 caliber on the current market. E-mail for complete details: email@example.com
List of parts with Build Specs:
Remington Model 700P Law Enforcement Model .300 Remington Ultra Mag
TPS Rings Alloy Steel, Medium, TSR 30mm. #30571
TPS XP Rem Base - 0 MOA - 7075 Alloy Steel.
Chrome Moly Vais Comp.
Harris Bipod S-BRM 6" to 9" Leg Notch, Swivel, HBP-SBR-M00
Super Sniper 10x42 30mm Rifle Scope SS10X42
Custom Build Work: Total I paid: $2101.18
1.) Set 4150 Chrome Moly Barrel Back 1.5 Turns, re-chamber with Match reamer .002 over GO.
2.) Lap Bolt Lugs and bolt face to receiver and barrel.
3.) Lap receiver to recoil lug and full length aluminum bedding block in HS precision stock.
4.) Cut barrel to 25.25”, 11 degree lapped target crown, thread, and install Vais Compensator.
5.) Check all threads, re-cut, and clean up as needed.
6.) Install and match TPS O MOA base.
7.) Trigger work, 2.5-3 lbs.
8.) Thread and install tactical oversized sniper bolt knob, supplied.
9.) Re-finish entire action in Duracoat Matt Black, no blasting on matched surfaces.
10.) Re-finnish HS Precision stock with Duracoat OD Green.
11.) Final check of crown with scope accuracy for test fire and re-crown if necessary.
Again this is a total custom build, invested $2101.18 from the ground up by a Gov/LE contractor.
Will Take $1850 NEW Complete w/everything. Shipped from my FFL in Ohio to your FFL. Will consider partial trades. NOT to be used for anything other than typical hunting, long range use, or to fullfill "God" role in SHTF scenarios. Thanks
.300 Ultra Magnun!
Trued/Lapped Bolt and Lugs:
All threads redone, bedding block blueprinted for reciever:
Yes it was built Hateca on this board.