HiPoint...

Gotta admit.  They see a market and a cheap way to get in and they jump on it.

Linky

I would think that a bolt for a blowback that could handle hot 10mm would have to be quite heavy.  I think I'll pass.

Bring that ugly little carbine out in 10mm and I will jump on it it like a duck on a june bug!

Those will sell faster than they can make them

I'll buy one. I just hope mags hold more than 10rds

I would bet good money that it is practically the same as the .40 just with some beefed up springs and heavier bolt.  So, I doubt much will change with the mags.

Makes me wonder if its based on the 45ACP version. If so would 10mm 1911 magazines work with the 1911 mag catch.

If it's based on the stouter .45 receiver and is rated to handle the hotter stuff like Underwood then they may have something that appeals to me.

I know the single stack low cap mags are a deal breaker for some but I had a 995TS that although not super accurate was reliable and ran everything.

The 4595 I have now seems to be as accurate as my (now gone) Just Right Carbine @ 50 yards. Sold the JRC for a TNW ASR 10mm carbine, which runs great. But factory Glock 10mm mags are only 15 rounds, 17 with a +2 baseplate. So a single stack 10 round HP mag isn't giving up much.

I kinda had my doubts about 10mm in a blowback carbine but my ASR 10mm seems to manage it just fine.

Entertaining the though of one of these in a HTA bullpup chassis with a 1911 mag release.

Sure looks like it. I have a friend who is really looking forward to this. I must admit that I love all the 10mm options we have nowadays.

Personally the only PCC I am interest in nowadays is the GMH-9 and that's mainly because it is identical to a gun I imagined in a novel.