Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 1/12/2002 6:08:32 PM EDT
Hey you gunsmiths out there,how is this done? Can I use a dremil tool with a metal polish bit??Thankful for any feedback!
Link Posted: 1/12/2002 7:25:18 PM EDT
Use your dremel with the white circular applicator and the red polishing compound. It should shine when finished.
Link Posted: 1/12/2002 11:29:13 PM EDT
Remember to only shine the metal. Do not change any of the angles on the feed ramp, or recontour any of the feed ramp!!!!
Your going for smooth, not changed.

Also, don't remove any metal from the barrel chamber feed. You can polish the bottom chamber cut, just don't remove any metal or you are going to have problems with ammo due to a unsupported case.
Link Posted: 1/13/2002 6:13:29 PM EDT

Originally Posted By Dano523:
just don't remove any metal or you are going to have problems with ammo due to a unsupported case.



Are we talking about AR feedramps ??? In this case, the chamber is not part of the feedramp. The AR15 chamber would not be touched if you were polishing the AR feedramp.
Top Top