Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Log In

A valid email is required.
Password is required.
Site Notices
4/25/2017 7:42:44 PM
Posted: 6/18/2002 10:05:20 PM EDT
Have three Hass verticle CNC mills and a new 4 axis late just begging to make some AR components. We have made some new products (Brownells has just accepted for their catalog) and if I can get the AR15.com crew to respond to my emails and get me on board in the equipment exchange I will offer free to AR15.com members for field test, until then any good new ideas out there on products you would like to see done?
Robert
Link Posted: 6/18/2002 10:40:36 PM EDT
How about a RAS forend that I dont have to give up a kidney for?
Link Posted: 6/19/2002 4:14:13 AM EDT
How about a machined bolt stop/release for the AR-10!!!!!!!!!!!!!!!!!!!
Link Posted: 6/19/2002 4:54:00 AM EDT

A FFRAS for the AR10 would be great.
Link Posted: 6/19/2002 5:01:32 AM EDT
If you had a press instead of a mill - I'd say:

Somebody ought to make some 223 clips in the design of the SKS/AK stripper clips. Ie, the long leaf spring bent tab retaining the shells, instead of the little brass tab that breaks off the 2nd time you use them.
Top Top