Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/5/2003 8:49:26 PM EDT
does anyone make a scout mount for the 10/22??

thanks for any help
Link Posted: 8/6/2003 1:29:36 PM EDT

Originally Posted By brewsky101:
a scout mount for the 10/22??

What is it?
Link Posted: 8/6/2003 1:56:24 PM EDT
its a mount that lets you you put optics farther forward for quicker target acquisition.
so the optic would be over the barrel instead of on the receiver.

does anybody know of one???
Link Posted: 8/6/2003 2:30:52 PM EDT
Maybe you could convince XS to come up with one.
Actually, could you make one of the existing models fit.
Link Posted: 8/6/2003 3:49:31 PM EDT
Link Posted: 8/6/2003 5:50:49 PM EDT
The cantilever mount is intended to mount to the barrel, but keep the scope over the receiver. I suppose you could push it forward, or mount it backward. But if you are going to go through the trouble of making holes in the barrel, this might be a better route:

originally posted by Big-Bore:
I like to use the Extended Powers Custom base, the one that mounts on the receiver and the barrel. You mount it on the receiver, then spot center mark the holes on the barrel and D&T them. It gives a longer scope base for a bit more latitude in scope placement.

From this thread:

But, I think a rail that used the existing front two holes in the receiver, and the dovetail for the original rear sight. It would be extra kewl if it incorporated an adjustable sight at the rear of the unit. This would give you a BUIS and it would increase the sight radius.
Top Top