Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 3/1/2006 1:33:34 PM EDT
I'm looking for a Ruger Gunsmith that could put some night sights on a P-Series pistol.

Anyone have any suggestions....good or bad??

I don't mind shipping the slide out for the work to be done...and done well.



Lex in NC
Link Posted: 3/1/2006 5:03:47 PM EDT
Call Cylinder & Slide & see who they might recommend??????

My .o2
Link Posted: 3/1/2006 5:23:39 PM EDT
Save the $$$ and buy something other than a ruger?
Link Posted: 3/2/2006 5:05:39 AM EDT
the sights on a p series are removable. the rear needs a small allen to loosen and then you might need a mallet and a dowel to get off. the front will require a much smaller tool. you might want to just go to your local gun store or range. if they have basic armorers tools around they can get the front sight off. then just put the new sights on in the reverse order.
Link Posted: 3/2/2006 7:25:18 AM EDT
with the proper roll pin punch, its a half hour job, tops. Unless, of course, you have all thumbs on both hands
Top Top