Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 3/11/2006 11:41:34 PM EDT
I just aquired 2 ITM Arms complete recivers. The receivers are marked on the left side directly behind the trigger pin. made in Cleveland Ohio.

Any one have any experiance with these receivers?
Link Posted: 3/12/2006 12:14:31 AM EDT
[Last Edit: 3/12/2006 12:15:15 AM EDT by Barrelburner]
They are AKA OOW (Ohio Ordnance Works). The 5.45 ones are considered very good. The older 7.62 ones have the selector hole slightly misplaced, resulting in a "selector gap." I'm not sure about the newer ones.

The only other complaint about them seems to be all the markings on the sides.
Link Posted: 3/12/2006 6:52:04 AM EDT
They are also not fully heat treated unless they have changed that. They are heat treated around the pin holes.

I have two Krinks built on them and 2 Vector underfolders built on them.
Link Posted: 3/12/2006 11:10:25 PM EDT
Thanks for the replies I'll post feed back after I get my builds finished.
Top Top