Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 10/15/2003 2:04:53 PM EDT
Once you have your AK(s) all clean, what do you use for lubrication and where?

Best regards, J
Link Posted: 10/15/2003 7:33:37 PM EDT
[Last Edit: 10/17/2003 7:07:15 PM EDT by msh]
A light film of Mobil 1, and a very light film of grease on the areas that show bright after a few hundred rounds.
Ed's Red to clean.
Rig Universal shaving brushed on the exterior.
Link Posted: 10/15/2003 8:51:41 PM EDT
Lately FP10 or Clenzoil to clean/lube most, Tetra for grease.
My car lives on Mobil1 though :)
Link Posted: 10/17/2003 3:18:01 PM EDT
TW25B oil and TW25B Grease.
Link Posted: 10/18/2003 9:29:25 PM EDT
tetra grease for moving part such as the rail, the bolt carrier, and along the magazine intake section. i put some one the magazine release device also.

i usually pour 2 teaspoons worth of mobil 1 synthetic oil down the barrel. the oil will lube the barrel up the best way. a lot of oil will run through the receiver and lube everthing in sight. about 1 teaspoon will make it way out the back of the receiver. this is where a nice rag come in. i wipe the oil off and use this excess oil to wipe the exterior of the gun. the gun will be very oil, too oily to touch. this is how i like my gun to be. i dont take chance with rust. i put the gun in the tactical bag then. a few days later, i take it out and use a paper towel a wipe the gun dry. there will be some oil inside the case, but it will act as extra lube when i put the gun back in.
Link Posted: 10/18/2003 9:31:22 PM EDT
i have a revolver since i was 14 and it has not seen any rust. i am 26 now. the gun was a gift. out in the country, kids get to use guns very early in life. my revolver is the s&w 629
Top Top