Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 4/3/2006 7:05:17 AM EDT
Like opinions, maybe some pics if people have them.
Link Posted: 4/3/2006 8:43:59 AM EDT
I'm working on one for an m70b1 in my spare time. it's ok but crude . the front of the receiver is too tall but you can spot weld a shim into it to hold the hand gaurd to the trunnion. milling machine will help you alot. the bolt guide rails are not sqaure and very crude but there is plenty of material there after you square the rails. don't use the prints that come with it! better yet spend fifteen bucks more & get the one Curtis at ak builder.com sells w/prints. I wouldn't buy another one but I'm not throwing away forty bucks either. good luck with your build! R1150R
Link Posted: 4/3/2006 10:37:05 AM EDT
Yea I received two yugo receivers from them; the magwell bottom and side dimples were a little crude and the left sides were a just a tad shorter than the right.

Now this is my fault - double measure everything on the included plan, Dont just wrap and cut, my FCG holes are a little high and I may have to cut a slot in the hammer to clear the spring. I'm thinking about ordering a replacement and writing this one off.

If the dimples and magwell are cleaned up, I would definately purchase from them again.

Good Luck
Hawk
Top Top