Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 3/29/2006 1:25:07 PM EDT

I have a Yugo "naked" kit. Does anyone know the correct size hole to drill in the barrel for the gas system?
TIA
Link Posted: 3/30/2006 3:41:50 AM EDT
I got one too for a milled receiver side-folder build. Hoping someone will answer soon - BUMP!!
Link Posted: 3/30/2006 6:01:00 PM EDT
[Last Edit: 3/30/2006 6:03:08 PM EDT by Tommy2399]
My friend and i use 1/8 with good results on 9 1/2 inch barrels. Haven't done any Krinks though.
Link Posted: 3/31/2006 4:57:57 AM EDT
Well I couldn't find the info I wanted anywhere. What I did was to remove the gas block from a Romy kit I had . The gas port measured .140". The closest bit I had measured .137. I drilled the hole with it and put the gun together. Functions just fine.
Link Posted: 4/1/2006 4:14:29 PM EDT
How hard was the build? I have basic mechanical skills but managed an m92 sidefolder from a demilled kit. What tools did you need?
Top Top