Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 2/26/2006 8:37:53 AM EDT
Hi, I was wondering if someone could give me some advice. I'm having a weird issue with the topcover/rear trunion/recoil assembally on my Yugo underfolder. There seems to be some sort of hangup in the part of the rear trunion that holds the recoil assembally. I understand that there is the pushbutton thing that holds the recoil assembally in place, but even when that is pushed in the recoil assembally doesnt slide easily. It seems like the channel it slides through has been bent? This makes it impossible to put the topcover back on, since the recoil assembally wont slide backwards to lock it in place. Anyone dealt with this before?
Link Posted: 2/26/2006 9:01:14 AM EDT
[Last Edit: 2/26/2006 9:19:43 AM EDT by millsusaf]
Sounds like your rear trunnion is a little off (tilted). Shave the botton of the your recoil spring.
Link Posted: 2/26/2006 9:51:52 AM EDT
Will that work on a Yugo one? It has the stuff on the underside...?


Originally Posted By millsusaf:
Sounds like your rear trunnion is a little off (tilted). Shave the botton of the your recoil spring.

Link Posted: 2/26/2006 2:51:35 PM EDT

Originally Posted By anr6t:
Will that work on a Yugo one? It has the stuff on the underside...?


Originally Posted By millsusaf:
Sounds like your rear trunnion is a little off (tilted). Shave the botton of the your recoil spring.




I am not sure what you mean by "underside".

I am refering to what's in the red circle. You may even have to grind the top of the trunnion a little also (where the red circle meets).


Link Posted: 2/26/2006 5:29:58 PM EDT
First make sure that the recoil spring is correct for the trunion..

I had one from a Bulgy that I had to grind the right corner(front) back to clear the button.

file a small portion off the bottom as stated above.

Good luck
Link Posted: 2/27/2006 8:08:34 AM EDT
It seems like I installed my rear trunion angled SLIGHTLY downward, and the recoil assembally is catching on the angled point. I'm going to try grinding down the bottom of the recoil assembally (where Mills circled) to try and make it fit. Thanks to everyone who responded/helped =)
Top Top