Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 2/22/2006 6:31:11 PM EDT
I assume that when one builds a krink kit with a can to avoid the SBR status, he must permanently attach the can and not simply thread it on. Must the can be welded? Would drilling a hole and pinning it in place be legally sufficient?

"Each man must for himself alone decide what is right and what is wrong, which course is patriotic and which isn't. You cannot shirk this and be a man. To decide against your conviction is to be an unqualified and excusable traitor, both to yourself and to your country, let men label you as they may"

-Mark Twain


Link Posted: 2/22/2006 7:04:52 PM EDT
you need to BLIND pin or silver solder
Link Posted: 2/22/2006 7:36:55 PM EDT
What's blind pinning? Sounds like maybe filing/grinding the ends of the pin so it's flush with the can and finishing it with the can? That would be hard to spot.

Thanks SOCA

"I am not an American, I am the American." -Mark Twain
Link Posted: 2/23/2006 7:44:30 AM EDT
Blind pinning means the hole does not go all the way through, so the pin cannot be pressed back out from the other side.
Link Posted: 2/23/2006 9:25:57 AM EDT
yes what he said
alot of people think it means you cant see the pin but actually it means
the pin gos into a blind hole (and a total pita to remove)
Top Top