Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 2/9/2006 8:29:45 PM EDT
I have a question, when I look at the print the rear height looks like 1.50, shouldnt it be 1.60? I am geting ready to cut some metal and dont want some useless chunks laying around.



Pleas help me!!!


Matt

Link Posted: 2/9/2006 9:51:45 PM EDT
[Last Edit: 2/9/2006 10:15:26 PM EDT by Parabellium]
to me it looks like it says 1.58 or 1.59

ETA: i think it says 1.59
another set of instructions has it listed as 1.60
Link Posted: 2/10/2006 2:22:50 AM EDT
[Last Edit: 2/10/2006 2:23:26 AM EDT by schmalts]
I just made one. I did it ti 1.59
Link Posted: 2/10/2006 5:04:09 AM EDT
Someone reworked the print into a .pdf... Its nice and you can print it too!

555th Jig, 8.5x11 PDF
www.dittmantechnologies.com/555thv2.pdf

-Smalls
Link Posted: 2/10/2006 6:24:26 AM EDT
Ya, now that I look at it on my giganto monitor it does look like 1.59. And then 1.16 at the small end. I will check out that PDF now.

OMP

Top Top