Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 1/18/2006 8:51:17 AM EDT
the front and rear trunnions? Can you weld metal to them and make a receiver? What is the little button at the back end for?
Link Posted: 1/18/2006 12:32:08 PM EDT
its been done, you have to mill the sides down to fit in the stamped receiver then weld away
Link Posted: 1/18/2006 1:04:54 PM EDT
btw, the button on the back of the rifle is for holding the dust cover and recoil spring in place when the rifle is used to fire rifle grenades....the recoil would apparantly send all the parts flying without the springloaded locking button....
Link Posted: 1/18/2006 6:09:20 PM EDT

Originally Posted By Stoney:
the front and rear trunnions? Can you weld metal to them and make a receiver? What is the little button at the back end for?



What kind of kit do you have? I am looking for a milled kit for a project and I would trade a nice Polish Underfolder or Tantial for a Milled Polish kit. E-mail me if you have any interest as I have been swamped with work the past couple weeks so I have not been able to hang out much.

QB
Top Top