Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 1/16/2006 7:35:52 AM EDT
I see a few options when searching rivets from McMaster.

the two that would apply are:
Low-Strength Plain C1006 Steel or
18-8 Stainless Steel

I'm guessing i want the plain C1006 steel. is this correct?

thanks
caspian
Link Posted: 1/16/2006 7:45:53 AM EDT
I've been ordering and using the 18-8 stainless steel revits, so I am not aware of the other revits mentioned.
Link Posted: 1/16/2006 7:47:09 AM EDT
have you parkerized a receiver with stainless? i thought stainless didn't take to parkerization.

thanks
caspian
Link Posted: 1/16/2006 7:52:46 AM EDT
I haven't parkerized any of my receivers. I basically been using Dupli-Color high temp engine paint to refinish my rifles. The finish has been wearing off on the high spots, but hey, it adds character to each of the rifles.
Top Top