Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 1/8/2006 5:49:51 PM EDT
My reciever is stamped 7.62, but my kit is for 5.45? I already had to buy a new rear trunion cause the 74 holes didn't line up with my reciever. Please tell me I don't have to get another reciever or kit.
Link Posted: 1/8/2006 6:17:07 PM EDT
What receiver did you buy and were the holes pre-drilled or did you make a mistake when you drilled the rear trunnion holes?
Link Posted: 1/8/2006 8:04:33 PM EDT
which receiver did you get?
Ewbanks are marked 7.62 but the ejector is 5.45 size and must be trimmed down for 7.62
Link Posted: 1/8/2006 10:20:04 PM EDT
A 7.62 magwell will be too big for a 5.45 mag.
Link Posted: 1/8/2006 10:53:15 PM EDT
I built a 74 on a Tapco flat/receiver and the magwell worked fine. The reason it worked is because the Tapco flats require you to finish parts of them dimensionally. The ejector on some of the 100% receivers will work because it is made to 74 length and you have to shave it down for a 47 build. So it depends on whose receiver you are using I guess.
Link Posted: 1/9/2006 12:37:38 AM EDT
It's a vulcan and the holes where already drilled.
Link Posted: 1/11/2006 12:26:44 PM EDT
So do I have to get a new kit, receiver, or am I good to go?
Link Posted: 1/11/2006 6:28:09 PM EDT
[Last Edit: 1/11/2006 6:35:08 PM EDT by JoeBud]
You're good to go. They are built to 74 specs and have to be fitted more for a 47. They are required to mark them with a caliber and more get built into 47's than 74's. Here's my AKS-74 built on a 7.62 marked Vulcan. No problems.
Link Posted: 1/12/2006 12:52:05 AM EDT
Thanks.
Link Posted: 1/12/2006 8:38:49 AM EDT

Originally Posted By JoeBud:
... They are required to mark them with a caliber ....



There is no such requirement.
I build my AKs from 80% flats, but I have bought several 100% AR receivers.
Under caliber, they are just stamped multi.
Link Posted: 1/14/2006 8:33:31 PM EDT
Built a bulgy 74 on a vulacn marked 7.62 Its a nice tight fit. Did need a little filing of the rails. Mag fits perfect.

The hole you're referring to is the #4 counting from the front to back. I had them welded on bothsides and redrilled it for the bulgy trunnion.

On a saiga conv. there are two holes left over above the PG. I filled these with plastics plugs that I found at Lowes in there fastenners section. Fit perfect and look just like a rivit. I don't know if this would work or be in the way of you drilling a new #4 hole.
Top Top