Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 3/26/2006 3:16:55 PM EDT
I bought a winter trigger guard and was going to install it but couldn't get the pin from the original flat guard free. I didn't want to hammer the bejeezus out of the receiver to get it out. From the manual it doesn't appear that there is any trick to this but I thought I'd check here.
Link Posted: 3/26/2006 3:31:03 PM EDT
[Last Edit: 3/27/2006 2:32:26 PM EDT by Minuteman419]
Support the back side of the boss where the pin will exit from with something that has a hole in it to: absorb the blow and allow the pin to pass through.

Same if re-installing pin as far as supporting back side of boss while punching pin in.

Danny
Link Posted: 3/26/2006 10:39:37 PM EDT
Link Posted: 3/27/2006 12:09:59 AM EDT
Link Posted: 3/27/2006 7:10:24 AM EDT

Originally Posted By Teknic:
It might take a nice first blow to get it moving.



I've used that phrase before
Top Top