Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 3/9/2006 12:45:49 PM EDT
Hey build experts,

The rear trigger guard hole is 1/8" correct?

-Thanks
Link Posted: 3/9/2006 1:33:14 PM EDT
I'm not sure of the actual hole's size, but the roll pin that fits into it is .093" (3/32") in diameter.
Link Posted: 3/11/2006 12:26:49 PM EDT
Are you sure it's that small? You know the hole I'm talking about? the trigger guard pin that does not swing down, but rather pivots.
Link Posted: 3/11/2006 1:30:52 PM EDT

Originally Posted By M4Madness:
I'm not sure of the actual hole's size, but the roll pin that fits into it is .093" (3/32") in diameter.



+1
Link Posted: 3/11/2006 3:50:09 PM EDT
The hole for the rear trigger guard pin is .1275. the roll pin is refered to as a 1/8 but measures a little bigger on the outside.
Link Posted: 3/14/2006 2:10:30 PM EDT

Originally Posted By j3_:
The hole for the rear trigger guard pin is .1275. the roll pin is refered to as a 1/8 but measures a little bigger on the outside.



I tested it with a drill bit. It's 1/8th thanks.
Link Posted: 3/14/2006 5:32:27 PM EDT
I think the drawings call for the hole slightly larger so the anodizing does not close the hole up making it to small. It can close the hole up as much as .002 total with .001 build up around the hole.
Top Top