Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 12/27/2005 11:47:25 AM EDT
My hammer pin is rotating...

Seems like that the hammer is not engaging the slots in the pin?
Link Posted: 12/27/2005 11:59:27 AM EDT
Hammer had a bent J spring in the middle of it that will catchs the annular groove in the center of the hammer pin. The pin spinning is normal due to the friction of the hammer j pin against the pin being stronger than the surface tension of the receiver holes against the pin (read keep the pins lube and let them spin.
Link Posted: 12/27/2005 5:20:33 PM EDT
normal

the slots are just to keep the pins from falling out.
Link Posted: 12/27/2005 6:36:43 PM EDT
Link Posted: 12/27/2005 7:06:53 PM EDT
It's not an issue if it is normal! :)
Top Top