Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 2/21/2006 4:40:01 PM EDT
There really wasn't a whole lot of decent info anywhere on the IOR ring height. Best info I found was from a dealer's post here on AR15.com, but it wasn't clear on a few details. So, since I bought a pair of these rings - I know the exact heights, so I thought I'd share them with everyone else.


These are all-steel, 30mm rings made by IOR. These are the hollowed out ones (some are solid), and they are the ones labeled "HIGH"...



Here are the measurements I got with a pair of calipers. The measurement to the middle of the scope is the best I could do...I seriously doubt that measurement is off more than a hundreth max. The other measurement is from the bottom of the scope. Both begin at the bottom of the ring base where the rings would contact the TOP of the flattop. Not from the bottom of the "hooks" that grip the rail. Picture says it all. NOTE: These rings are not split in the middle. They are split like 60% of the way up, so they are not halves. Pic says it all.




Link Posted: 2/21/2006 7:03:39 PM EDT
[Last Edit: 2/21/2006 7:04:17 PM EDT by ar556223]
How much coin? That's about the height I am looking for.
Link Posted: 2/21/2006 9:34:17 PM EDT
SWFA has them for $99. I got them for less because I bought an IOR scope from USAoptics.


Top Top