Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 5/14/2003 4:52:10 PM EDT
Has anyone installed and tested the new PRI flip-up front sight with the (4) set screws?

This version was just brought to my attention by Wes at M.S.T.N.

The old version was to cross over cap screws, if I understand correctly you had to remove some of the barrel material to install.

They have both available.

Need help quickly, hoping to make purchase soon.

Link Posted: 5/15/2003 1:03:19 AM EDT
Dustoff,I just bought one from WES with my SPR barrel.I will test it out this weekend.If you go to Compass Lake Enginearing's web sight they have a section on zeroing your sights.Initialy you set your rear sight in the center and adjust the front.This will insure front sight is centered and give you the maximum amount of windadge in both directions.I havent shot mine yet but I would still reccomend it.SJR556.
Top Top