Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/6/2003 4:24:54 PM EDT
[Last Edit: 8/6/2003 4:59:36 PM EDT by usma89]
I finally got my 300 Whisper upper today! I tried to put it on my RRA lower, but the front pivot pin will not go in without a lot of nylon hammer action, it does not line up properly.
Also when in, I cannot open up the rifle with the back pin out. The back pin goes in and out fine. My Bushmaster/Colt/and PWA lowers all work just fine. Is there a solution?
Link Posted: 8/6/2003 4:59:07 PM EDT
It will wear in once you use it for awhile. I don't ever recomend building mongrels unless you don't mind paying for the problems of matting non mil spec to another non mil spec. The after market gun makers don't work from the same prints! Good shootin, Jack
Link Posted: 8/6/2003 5:23:26 PM EDT
Top Top