Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 11/26/2002 1:38:34 PM EDT
[Last Edit: 11/26/2002 1:41:13 PM EDT by 45Cal]
Good afternoon,

I just purchased a used KAC foregrip, and was wondering if I was missing a part. The KAC foregrip has a hole through the top part of the grip. Which I assume is for a crossbolt that would index against the notches in the rail. The grip did not come with a crossbolt, and I am wondering if it should of. Please let me know if I am missing the part.

I e-mailed the person I purchased it from, and he stated that the grip uses the center post to lock the grip in place.

Thanks,

45Cal
Link Posted: 11/26/2002 1:44:33 PM EDT
Link Posted: 11/26/2002 2:17:31 PM EDT
PaulE, Thanks for your reply! Especially since it came from the authority on KAC products. Will be giving you or Wes a call next year when I am ready to embark on another project. Take care, 45Cal
Link Posted: 11/26/2002 5:13:29 PM EDT
I think the hole is there so you can line it up with one of the cross slots before tightening the grip.
Link Posted: 11/28/2002 5:01:58 AM EDT
This is corret. The hole was added so to observe the "tit" on the end of the center shaft lining-up with a groove. Always align to the middle of a groove, as "cutting the edge" of a rail with the tit will destroy it over time. ColdBlue sends...
Top Top