Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 1/20/2006 5:53:47 AM EDT
Is it necessary to modify the holes on the hammer and trigger when installing these pins. The reason i ask is that there is alittle play in the receiver pin holes so i just wanted to tighten them up. but there is not really any play with the pins in the trigger and hammer holes. Thanks
Link Posted: 1/20/2006 7:03:10 AM EDT
reciever pin holes? so you are asking about the takedown and pivot pins?

what are you asking? you ask about modifying the hammer and trigger pins but state there isnt anything wrong with them?


Link Posted: 1/20/2006 8:17:52 AM EDT
the springs when installed correctly will keep your pins from moving out.

I think what he is saying is that the fire control pins on his lower are of a larger dia than the holes in the hammer and trigger for there respective pins.

Side note Hammer has a J spring in there so it will appear to ghave a perfect fit.
Link Posted: 1/20/2006 2:38:01 PM EDT
no what i was asking was kns trigger and hammer pins come in 3 different sizes 1 standard, 1 oversided standard, and 1 for colt large pins. i would like toknow if the oversized pins which are .155" instead of the standard size .154" will simply fit the hammer and trigger holes with out modifing the hammer and trigger pin holes. My receiver has a little bit of play in those holes which is why i would like to use the oversized holes if it is as simple removing the old ones and replacing with oversized ones. Thanks
Link Posted: 1/20/2006 2:46:52 PM EDT
yes, but the oversized ones require slight tapping/persuading on new recievers
Link Posted: 1/20/2006 2:54:25 PM EDT
KNS also sells a reamer for some of their pins........
Top Top