Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 12/17/2005 7:30:02 PM EDT
I have an RRA lower with a 9mm hammer.

I removed the standard sear and hammer spring and replaced with the jp yellows. The pull is smooth but it is almost to light. Could I mix the springs around a bit to see how it changes or would this not be a good idea?

Thanks
Link Posted: 12/17/2005 7:33:14 PM EDT
I see no reason why you couldn't experiment with different spring combinations.
Link Posted: 12/17/2005 7:40:07 PM EDT
I did that with a Yellow Tavern spring set on my SPRish build..I mixed and matched until I found the right combo that I liked...

It worked well..
Link Posted: 12/18/2005 3:46:56 AM EDT
i have the same problem with my 9mm, replaced with jp yellow springs and think its too light as well.


didnt think to mix&match the springs.
Link Posted: 12/18/2005 6:14:12 AM EDT

Originally Posted By eklikwhoa:
i have the same problem with my 9mm, replaced with jp yellow springs and think its too light as well.


didnt think to mix&match the springs.



That was my problem with the springs I got from Yellow Tavern. I started to mix and match and found a nice mix...
Link Posted: 12/18/2005 6:16:17 AM EDT

Originally Posted By GIDDS-45:
I have an RRA lower with a 9mm hammer.

I removed the standard sear and hammer spring and replaced with the jp yellows. The pull is smooth but it is almost to light. Could I mix the springs around a bit to see how it changes or would this not be a good idea?

Thanks



If its just a "fun gun", you may as well play around until you get what you like.
Top Top