Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 6/30/2003 5:36:12 PM EDT
I just put a 20" kit together for my dad. A cleaning rod w/patch meets substantial resistence at the gas port in the barrel... there seems to be a burr where the gas port was drilled.

Is this safe to shoot? If so will firing it smooth it out? Has anyone else noticed this? I am also able to see the hole when looking into the barrel at the muzzle. I haven't had this problem with my AR nor can I really see the gas port hole.

Link Posted: 6/30/2003 7:08:51 PM EDT
Common question here with J&T barrels, obviuosly they are not test fired, because if they were, you would have never seen the chip/burr hanging down,,, fire a couple runds, and forget about it.
Top Top