Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 2/19/2006 9:02:13 AM EDT
Hi guys.

I plan on adding a YHM free float and I know I will need to remove the barrel nut and delta ring.

Do I need an action block or could I just use a shaped peice of hardwood slid up into the magwell and tightened in a vice.
Link Posted: 2/19/2006 9:04:47 AM EDT
I would get the action block. You always eventually get one anyway. The wood is going to slip and gouge the crap out of something when you least expect it.
Link Posted: 2/19/2006 3:13:43 PM EDT
I suggest the clamshell block for the upper. You may be OK to remove the barrel with a magwell block, but you risk twisting something if you need to wrench hard on the nut going back together.
Top Top