Ok so I am going to be building my first DIY bluetooth speaker. I may be thinking about this all wrong, but here is what I have planned.
I picked out a bluetooth amp board that is 2x30 watts, and is rated from 4-8 ohms. I picked a pair of drivers that are 4" full range 30watts RMS 8 ohms.
I am thinking I want to add 2 tweeters into the mix, and wire them in parallel with the main drivers. I am not sure which tweeters, but they will be 8 ohms
as well. This should if I understand correctly make each set of speaker 4 ohms with the tweeters.
The main questions I have are this. What CAP do I need to wire to the tweeters, and will the CAP change the impedance of the speakers wired in parallel?
The last questions are this. Do I even need tweeters, or will they be a waste of time and money. I am making the speaker for my wife so she can listen to
music in the kitchen while she is making me sammiches. It's going to be her christmas present. Never wired anything like that up before. Most of it is plug and
play, but I get confused when it comes to numbers, and math with all this audio stuff. Below is a list of components I plan on using for the build.
I NEED HALP!!!!
Bluetooth amp board
4" Dayton Drivers
18650 battery board
These tweeters are the ones I want, but they are 6ohm. Will they work??? Remember I am also needing to know which CAP
to use in conjunction with these.
tweeters
Thanks in advance for the help.