I posted this here
, but figured some in this forum may be interested.
A couple of nights ago I pulled out some new D&H mags, disassembled them, and installed Magpul Gen 2 enhanced (gray) followers and a mix of Ranger and Lumpy plates. I made some observations which folks who have not installed these may find interesting should they decide to install any of these.
1. The followers had a fair amount of flash around the edge of the upper surface. While I figured this would likely be of no functional consequence, I wanted to confirm this. Before joining each follower and spring, I put each follower into it's mag body and let it drop toward the top of the mag. In each case, the follower slid to the top of the mag without resistance. Good stuff -- no worries about the flash. This test may be more relevant with other mag brands or Gen 1 followers.
2. Regarding the Ranger and Lumpy plates, each had some amount of rubber flash covering part of the stainless steel tabs that slide under the corresponding mag body tabs. In most cases, this flash was of no consequence. In some cases, however, it bunched up as the plates were slid on, making it difficult to slide them all the way home. Not a big deal, but on many of the plates, I trimmed the flash with a small knife to help the plates slide home without undue force.
3. Also regarding the Ranger and Lumpy plates, some of the lock plates had flash in the form of a cylindrical molding protrusion just below the tab that pops up behind the plate. In a couple of cases, I think it caused resistance to the tab popping up like it should, so I checked each lock plate and trimmed as necessary.
I don't consider any of these as significant issues, just by-products of mass production molding. I'm happy with each Magpul product I've tried. Maybe it's just my anal-retentive Engineer personality, but I felt inclined to take a few extra minutes to make sure everything went together as intended, and I though I'd share with the class.