Quoted:
Quoted:
Wow...
and to think I sold a Malkoff/Z49 modded 6P and went and bought a M600A and swapped off the KL4 for a KX2C head and bought a Z61 cap and LT mount just b/c I wanted an in-line setup when all I needed to do was wait 1 week and look here. I am sickened.
12_gauge,
Could you put that in a spread-sheet format ?
Yes, also, I would like to link you to the M60 LED module I installed. When I called to place an order with one of your staff, he was unfamiliar with the unit I was using. It is in the same quality league as the stuff that rolls out of your shop (used to be all hand-made actually) and I think that it may interest you, that is, if you have any interest in tactical lights.
Malkoff
Long story short, it has almost 3x the output of a P6LED, runs for about 90 minutes, and is made like a brick outhouse, and is a lot less "purple" in tint. Think X300 with a HAIR less throw, but a million-times more spill. The "W" variant of it is an LED that puts out light at about the 5,000K spectrum, making it only a little "whiter" than an over-driven incan. Basically, awesome color perception rivaling that of an incandescent.
My setup:
6PLED
Malkoff M60 and then M60W later
LT-606
Z49 clicky-cap
FM-34 beam-shaper
Beam-shot:
My new setup:
Scout M600A
Replaced KL4 with KX2C LED head
Z61 clicky, as the guard on the Z68 is annoying, and the cap can be twisted to "lock-out" anyways.
LT scout mount
Beam-shot of X300, which uses the same TIR/Cree as the KX2C unit, and that your staffer was so impressed with (rightfully so):
Not fair to the X300 was that as you can see, it was taken with ambient light pollution.
F04 beam diffuser.