Or do I just have to shrug my shoulders and not be able to get the lever to work on this particular lower?
Denny's Guns billet lower - apparently the extra built-up metal around the area where the BAD lever pivots is interfering with it - ergo, it won't allow me to hold the bolt open as it will not depress the bolt catch all the way down.
Not a problem on any of my other lowers, just this one. I suppose I could Dremel out a hunk of metal down the side of the BAD lever but that would probably make it more prone to eventually break as it would take about half of the width of the metal down the lever. If there was a way of getting a longer piece of metal where it screws into the paddle therefore pushing the BAD lever further back that would work.