Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 9/2/2004 4:26:34 PM EST
With the threading of my AR10 barrel?

Don't really need any of the "Well I hear Jim was great over at Pheonix Armory" stuff, prefer to use someone that is known to be reliable and competent.......

I know it's just threading, but imagine what would happen if I had a baffle strike due to a crappy 'smith? Someday, this 10 will sport a can.....
Link Posted: 9/2/2004 4:50:57 PM EST
Link Posted: 9/2/2004 5:17:44 PM EST
[Last Edit: 9/3/2004 8:25:13 AM EST by azexarms]
The prob I have is that I dont do enough AR10s to justify their receiver fixture and bbl nut wrench.

Buy them and give them to me and I'll do the work for free.

D.
AZEX
Link Posted: 9/2/2004 9:05:48 PM EST


Derek my AR10 is already threaded. But the muzzle break is pinned and welded on.

Will this be a problem for you to get the muzzle break off? And will you still need an AR10 barrel wrench to do this?

Also will anyone have flash hiders for the AR10. I think their 5/8 X 24mm?
Link Posted: 9/2/2004 9:12:27 PM EST
... tagged for interest, I need an AR10 barrel threaded as well.
Link Posted: 9/3/2004 8:24:51 AM EST
I would really need to properly remove the bbl to lathe turn the welds off. The pin I'm not worried about, except as anal as you AR10 guys are about "accuracy concerns" it may actually be more beneficial to cut and rethread, rather than take a chance on even putting a little twist in your undies....err...muzzle.

Even if we cut and rethread, I'd still need to properly remove the bbl.

D.
AZEX
Top Top