Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 4/17/2008 7:08:10 AM EST
I've done my first two builds (del-ton kit and one homemade) just recently, and have been using a barrel vise. Now after more research i've learned this can put alot of stress on the alignment pin and i'd like to start using a receiver vise block. Is there anyone local that would stock these or am i going to have to go the midway or brownells route? Thanks!
Link Posted: 4/17/2008 10:59:48 AM EST
Where is considered local?
Top Top