Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 8/25/2005 2:58:17 PM EDT
I just recieved a Wilson two piece guide rod and bushing to replace the dual spring guide rod it came with. It states i need to mill .070 off the slide apron on notched side. Would it be okay to use the Stock Bushing that came on the pistol, i put it together using the stock bushing and it fits fine.
Link Posted: 8/25/2005 4:41:09 PM EDT
I owned a Champion a few years ago, but it did not have a barrel bushing. The barrel was conical near the muzzle and fit directly to the slide.
Link Posted: 8/25/2005 4:44:19 PM EDT
Sorry, I guess you are talking about the reverse plug for the guide rod. I had the Wilson guide rod as well but it was installed by a local gunsmith.
Link Posted: 8/25/2005 5:25:29 PM EDT
yeah, the reverse plug is what i meant. i tried it with the stock bushing, but after racking the slide a few times, it feels like there is a lot of play in the slide and frame, i think i'll just take it to the local smith and have him make the cut.
Link Posted: 8/26/2005 5:28:54 PM EDT
That way you won't have to worry about it, and it shouldn't cost much.
Top Top