Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/4/2006 12:32:43 PM EST
Is it O.K. to round the front edge of the cylinder on my .357 carry gun? I've seen this done on larger guns, but how much is too much? It's a Taurus 605, in case anyone was about to have a stroke.
Link Posted: 2/7/2006 2:09:23 PM EST
Come on, I know I'm not the only do it yourselfer here, is this safe to do?
Link Posted: 2/8/2006 5:17:13 AM EST
What is the advantage of doing this? I've seen it also, but never considered it a needed mod.
Link Posted: 2/8/2006 10:43:48 AM EST
Smooths the sharp front edge of the cylinder. Makes it easier to holster.
Link Posted: 2/8/2006 1:03:43 PM EST
It's not really an issue, unless you round it so much that it allows excess gas to escape from the rear of the barrel.

In that case, you can start getting gas, powder particles and even bullet metal blown back toward you.

In short, beveling the front of the cylinder slightly is OK, but don't take it too far.
Link Posted: 2/9/2006 1:50:09 PM EST
Top Top