Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/16/2020 9:48:49 PM
Posted: 11/20/2012 5:54:55 AM EST
picked up 4 47d on the EE board with standard basepads. Thought they would work in my SR1911 with S&A magwell but they are just a bit short. So looking on the WC site they have have extended plastic pads and standard plastic pads. but the standard plastics look longer than the standard metal (what i have)

Can someone explain what i need?

Link Posted: 11/20/2012 6:30:38 AM EST
Originally Posted By evnash:
picked up 4 47d on the EE board with standard basepads. Thought they would work in my SR1911 with S&A magwell but they are just a bit short. So looking on the WC site they have have extended plastic pads and standard plastic pads. but the standard plastics look longer than the standard metal (what i have)

Can someone explain what i need?



The metal baseplates are "low profile" baseplates.

Not sure what you're looking for - but the stardard plastic baseplates will work with the S&A magwell.

~Augee
Link Posted: 11/20/2012 6:47:14 AM EST
[Last Edit: 11/20/2012 6:48:03 AM EST by Gregory_K]
Been a while, but the .350 (std plastic ht) should work. I know the .625 work.

measure how much you need then measure the thickness of your basepad and then you will know.
Link Posted: 11/20/2012 7:51:47 AM EST
[Last Edit: 11/20/2012 7:52:48 AM EST by SPTiger]
I don't know how long the S&A magwell is, but the .350 pads work fine with my Sig Tac Ops w/extended magwell. I use both Wilson 47 and 47D mags with that gun.
Link Posted: 11/20/2012 9:26:23 AM EST

Originally Posted By evnash:
picked up 4 47d on the EE board with standard basepads. Thought they would work in my SR1911 with S&A magwell but they are just a bit short. So looking on the WC site they have have extended plastic pads and standard plastic pads. but the standard plastics look longer than the standard metal (what i have)

Can someone explain what i need?



If the below picture explains the problem, a file or sandpaper is what you need...




Link Posted: 11/20/2012 11:15:50 AM EST
thx for the help guys. i figured out the problem. The ones i got on ebay were the low profile steel. seller had them titled wrong. so they are on the EE here now. ordering the standard plastic pads now.
Top Top