Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Page Handguns » FN
Posted: 9/27/2017 11:41:37 AM EDT
I have not seen anyone offering to mill 509 slides for RMR's, etc. Does anyone do this? Or is the 509 too new, or there is some issue I don't know about?
TIA!
Link Posted: 10/9/2017 7:22:16 PM EDT
I want to say atei and CNC have both experimented with them.

Not totally positive about atei, it could have also been agency.

Hopefully a few leads for you to run down.
Link Posted: 12/23/2017 5:18:25 PM EDT
http://www.parkermountainmachine.com/store/p310/PMM_FNH_509_RMR_%26_Lightening_Slide_Cut_Service_.html

Check this out.
Link Posted: 4/12/2018 6:59:17 PM EDT
I know primary machine is doing the FNS but not for the RMR. they told me the slide was too narrow for an rmr but the can do it for the Leupold DPP. I'm waiting for my DPP to show up from leupold and i'll mail it all off to them...$160 for machining and cerakote on the slide...not a bad deal. It may warrant an email to them to see if they can do the 509
Page Handguns » FN
Top Top