Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
Member Login

Site Notices
Posted: 9/9/2013 2:22:30 PM EDT
I need a allen wrench for the rear sight on my M&P's. I bought a 1/16" Ball Hex driver from Menards last night and tried it on my 40c and it started rounding off. Tried it on my FS45, Shield, and it did the same. If everyone says it is a 1/16" and this one doesn't work, what should I do?
Link Posted: 9/9/2013 2:54:40 PM EDT
3/32s I believe.

NVM.
Link Posted: 9/9/2013 3:31:34 PM EDT
Link Posted: 9/9/2013 3:40:49 PM EDT
You're a guy and you don't have a set of allen wrenches? I think I have this set and used one from it.

http://www.harborfreight.com/25-piece-extra-long-hex-key-set-5962.html
Link Posted: 9/9/2013 4:45:04 PM EDT
Discussion ForumsJump to Quoted PostQuote History
Quoted:
You're a guy and you don't have a set of allen wrenches? I think I have this set and used one from it.

http://www.harborfreight.com/25-piece-extra-long-hex-key-set-5962.html
View Quote


Oh I've got plenty of Allen wrenches, just nothing that small
Link Posted: 9/9/2013 9:52:31 PM EDT
1.6 mm or 0.063 is what i use
Link Posted: 9/10/2013 5:06:35 AM EDT
Well I took back the ball-ended one last night and found some "precision" drivers that had a 1/16" hex bit in the kit. Brought it home and it worked like a charm!
Top Top