Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/3/2005 10:23:06 AM EDT
[Last Edit: 9/3/2005 10:28:55 AM EDT by TerryG]
I keep getting failure to feed's, usually the first round from the magazine. I have been told to polish the feed ramp. I don't own a Dremel tool, and it seems a bit silly to buy one for a one time use. Is there any other means of polishing the feed ramp? If not, what is the procedure with the Dremel? Thanks for any help.
Link Posted: 9/3/2005 10:53:18 AM EDT

Originally Posted By TerryG:
I keep getting failure to feed's, usually the first round from the magazine. I have been told to polish the feed ramp. I don't own a Dremel tool, and it seems a bit silly to buy one for a one time use. Is there any other means of polishing the feed ramp? If not, what is the procedure with the Dremel? Thanks for any help.



[mocking]Don't....own....a.....dremel???[/mocking]

Buy one; you will certainly find uses for it. With the dremel, use a felt tip and jewler's rouge to polish the ramp. Alternatively, you can use a wooden dowel wrapped in cloth with jewler's rouge, but that takes much longer than using the dremel.
Top Top