Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 8/19/2017 8:02:21 PM EST
[Last Edit: 8/19/2017 8:05:22 PM EST by OilfieldTrash78]
Finally got to shoot my RMRed 19. The first few shots were fine, then I noticed the RMR kind of flashed during the shots, and now it is like a big blur. What would cause this? I changed batteries, and it it still the same.

Thanks

ETA: Its not my eyes, because my Burris FF3 looks fine, and the RMR looked fine until I ran rounds through it
Link Posted: 8/19/2017 11:12:15 PM EST
Battery contacts probably. Not sure if your using sealing plate but it helps. I use sealing plate wrapped in kapton tape and it works for the three i own. I will admit my first one had to get sent to trijicon and since it's back it's worked flawless after like 3k rounds. There's a company that sells a sealing plate that pushes the battery further up into optic to make better contact.
Link Posted: 8/20/2017 12:24:41 AM EST
Mine turned into a big blurry blob too. It was replaced by trijicon. Try cleaning the emitter and glass. If it's still a blurry blob i would give trijicon a call.
Link Posted: 8/20/2017 4:41:05 PM EST
I just ordered Trijicon's Type 2 RMR's. They are supposed to have hardened electronics to take the beating from pistol slide installations. Serial numbers begin in the 400,000 range.
Link Posted: 8/21/2017 5:45:05 PM EST
I emailed Trijicon. Just waiting to hear back
Link Posted: 8/23/2017 9:51:04 AM EST
Link Posted: 8/23/2017 3:43:35 PM EST
Discussion ForumsJump to Quoted PostQuote History
Originally Posted By TCBA_Joe:
Piece of electrical tape on the bottom of the battery

And bend the side battery contact. (Good info on this in the Roland Special thread)
https://www.AR15.Com/media/mediaFiles/108584/20170711-103026-251389.jpg
View Quote
I don't think he's experiencing the flicker issue some of us have seen... it sounds like an emitter issue that Trijicon will need to remedy for him.
Link Posted: 8/23/2017 4:21:14 PM EST
Discussion ForumsJump to Quoted PostQuote History
Originally Posted By OiRogers:


I don't think he's experiencing the flicker issue some of us have seen... it sounds like an emitter issue that Trijicon will need to remedy for him.
View Quote
That is correct. I have a Battle Werx anti flicker plate installed. The dot is just a big starburst now. I received an RMA from Trijicon, so I am sending it back.
Top Top