Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 9/5/2010 8:06:09 AM EST
I bought the +2 pierce extension for my G23. However when I replace the bottom floor plate assembly with the new Pierce one and do a function check it fails to lock the slide to the rear on a empty mag. Do I need a stiffer or longer spring?
Link Posted: 9/5/2010 8:23:06 AM EST
Yes, I believe so.
Link Posted: 9/5/2010 8:25:29 AM EST
I put Wolff extra powder springs in mine... they work fine. I run a G27.
Link Posted: 9/6/2010 5:38:20 PM EST
You shouldn't. I ran a G23 mag with that extension for a bit (w/ stock spring), to test it, and it always locked the slide back. I didn't like it because it tended to "bow" downward when the mag was fully loaded. As it if was going to pop off. And it DID in fact pop off in a drop test.

The factory Glock +2's are much sturdier.
Top Top