Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 7/8/2003 5:44:59 PM EST
Does anyone have a set of machinist drawings showing how to cut a 1911 for Novak lo-mounts? This is kind of a time sensative thing, so any help is really appreciated. ST
Link Posted: 7/8/2003 9:05:32 PM EST
With each Novak rear sight is packed a machinist's drawing. Two cuts are all that are done. You do need a specific dovetail cutter: .395"x65 degrees. Very simple cut though.
Hope this helps
Link Posted: 7/9/2003 8:03:06 AM EST
I know there is supposed to be one, just not with mine. Thanks, though. ST
Link Posted: 7/14/2003 6:27:34 PM EST
Look here if you haven't found the drawing you need.

www.blindhogg.com/gunsmith/novak.html
Top Top