Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 10/2/2005 5:58:59 PM EDT
I just order a Scherer 3.5 lb. trigger Connector for my glock 17.
Recently installed a exstended slide stop & exstended mag release,also a SS uncaptured guide rod.

The question I have about installing the connector, can I just remove rear grip pin?

Are, do I have to completly take my lower apart in order to insatll the new connector?

Your input is much appreciated.


Thanks in advance.


TG
Link Posted: 10/2/2005 7:10:27 PM EDT
You have to remove all the pins. Trigger pin, locking block pin if you have one, and trigger housing pin.

THen just move the whole trigger assembly out of the reciever, take off the trigger/trigger bar connected to the spring, and you're at the connector. Remove the connector, replace with connector of chioce, and reassemble.
Link Posted: 10/2/2005 7:27:15 PM EDT
Thanks, was hoping by removing the rear pin, that the trigger bar would pivot upwardly.

I have no problem taking my glock apart,just havent ever done it yet.

TG
Link Posted: 10/3/2005 6:41:50 AM EDT
Top Top